http://dbd.game/killswitch
Rites of Judgment Bugged!? PS4
So I noticed that the rites of judgment trail will instantly start to disappear after putting it down. I don’t really know what causes it. Sometimes it works sometimes it doesn’t. One place that I tested a lot and it always disappeared was trying to create quick border around a hooked survivor. The trail will vanish within 2 seconds. Is anyone else experiencing this?
Comments
-
I think it is a bit glitchy. I was upstairs in Game map, Pyramid Head was below me putting his trail down and the barbed wire appeared upstairs. Pretty sure it shouldn't jump floors like that. 😂
2 -
I'm pretty sure that if you place it close to hooks, gens or gates it automatically disappears
0 -
I’ve also noticed this, not sure if it’s intended or not.
0 -
I’ve noticed this too. I tested and it turns out it doesn’t matter if you start it or end near the hook, if it’s at all near the hook or gate the trail disappears. This might also go for cages but I haven’t tried that yet. I’m assuming this is intentional to prevent the hooked survivor from landing into a trench and be instantly tormented.
Post edited by Spirez on1 -
Damn that sucks. I thought that trapping around the hook would have been a really good strategy to use.
0 -
Even generators can’t have a trail around them.
0 -
Gens, hooks, gates, and I believe cages cannot have a trail around them and will disappear 3 seconds after being placed, in comparison or the 75 seconds they usually spend on the ground. This is intended.
0
