Visit the Kill Switch Master List for more information on this and other current known issues: https://forums.bhvr.com/dead-by-daylight/kb/articles/299-kill-switch-master-list
Get all the details on our forums: https://forums.bhvr.com/dead-by-daylight/discussion/436478/sign-up-now-to-receive-a-recap-of-your-2024-dead-by-daylight-stats/p1?new=1
How about we buff hillbilly's base turning rate mid-sprint.
Imagine if we don't nerf billy's base or addons and just make his turn rate a tad higher,like 25%? There will be so much more hilarious ######### happening with long sprints on open maps...
BHVR,c'mon
Comments
-
How about... no. You should of played this game in 2017. Every match was a billy over and over and over. He used to have op turning addons and I would rather not have that happen again. Billy is fine where he is. I do not believe tho he needed a heating mechanic
1 -
I disagree, turning add ons were not the problem. It was his reduce charge time add ons that were insane
8 -
as a billy main, ive always wondered this myself and i have noticed that billys base turn rate is relatively okay, his turn rate is only bad when using engravings. Due to the extra speed from engravings it gives you less time to turn and make less cuts due to his additional speed giving you less “wiggle room”.
when using double engravings you can pretty much only move forward with no yaw speed left and right, i think that’s a problem.
Post edited by frit on1 -
His turn rate is nowhere near adequate. That's why you have to aim at the survivors' feet as they're spinning into you, because once you let that chainsaw go and the survivor isn't directly in front of it, there's no way you can possibly turn hard enough to hit them, which results in a point-blank miss and a chase reset.
1 -
They can do what they want with Billy but, until the take off the repetitive roar and the high pitched screeching chainsaw after a few seconds of sprinting, i will only play him if necessary for dailies or challenges.
So mind boggling annoying that #########.
0 -
Double engravings and lopro chains are his only fun add ons though and viable against good survivors.
Curving/flicking survivors with double engravings around loops and skybilly is basically the fun meta on him now and pretty much has been since…forever even before overheat.. Increasing his base turn rate would just be dumb considering there’s add ons for that already.
0 -
I thought the roar added to him. Having his speed be fueled by unbridled rage when he uses his chainsaw. It makes him terrifying imo.
0 -
Not if you prefer to play with mainly the chainsaw and it's just the same sample again and again and again. Atleast give him a variety of screams so it feels slightly fresh every time.
Also in my mind they just added it mainly as a "dodge now please" audio cue for survivor.
1 -
here's extra 3% for you.
0 -
Oh thanks bestie,didn't know I had a third addon slot!
1 -
I can agree there. It does need more kinds of roars.
0
