We have temporarily disabled Baermar Uraz's Ugly Sweater Cosmetic (all queues) due to issues affecting gameplay.

Visit the Kill Switch Master List for more information on this and other current known issues: https://forums.bhvr.com/dead-by-daylight/kb/articles/299-kill-switch-master-list

Fellow console gamers...

jsphwtsn
jsphwtsn Member Posts: 79

What sensitivity do you run for both survivor and killer? I’ve been running the default for almost 3 years now and never really thought to change it, but now I’m wondering if I’ve been foolish for doing so? Does a higher sensitivity have much impact on gameplay? (Note: I don’t play Huntress and Nurse because of console frames)

Comments

  • MissKitty95
    MissKitty95 Member Posts: 786

    Ps4 I was on 100 turnt it down to 85 survivors, killer is the same I think

  • Mew
    Mew Member Posts: 1,835

    pretty sure my survivor sensitivity is 75, and killer is 65

  • bm33
    bm33 Member Posts: 8,298

    I have it at the default. Think at this point it's too late for me to change it, I'm too used to how it plays.

  • CrowFoxy
    CrowFoxy Member Posts: 1,310

    I use a controller on PC, pretty sure it's about the same.

    I use about 50% even when playing Nurse and Huntress. I just need it to not be so sensitive.

  • CriminalMind_ITA
    CriminalMind_ITA Member Posts: 93

    Survivor 100, killer 85

  • Inji
    Inji Member Posts: 1,096

    Not a console player, but am a controller player. On survivor I use 80% sensitivity

  • Cheers
    Cheers Member Posts: 3,426
    edited July 2020

    On survivor and killer I personally use 100%.

  • andyollolloll
    andyollolloll Member Posts: 940

    If I have to 360 as a killer or survivor then I set my sensitivity to 100%.

  • TragicSolitude
    TragicSolitude Member, Alpha Surveyor Posts: 7,469

    Killer is at 100% sensitivity. I think survivor is like 80%, I dunno. I should mess around with the survivor sensitivity and see if it has any effect, but I've been lazy about it.

  • Deathslinger
    Deathslinger Member Posts: 570

    I’m ps4, 80% each.

  • Waldbeere
    Waldbeere Member Posts: 168

    I think you should use the settings that fit the best for you. If you do well with a 50% sensitivity for a survivor there is no need to change it.

    I personally use 100% for survivor and I think 60% for the most killers. But if I play huntress I use 50% or 55%. I guess it was 50%. My hit rate is much higher below 60% with her hatchets.

    I think it's a total individual thing 🤷‍♂️.

  • xBEATDOWNSx
    xBEATDOWNSx Member Posts: 636

    Play on Xbox

    Killer is at 85

    Survivor is at 80

  • ohheyitsbobcat
    ohheyitsbobcat Member Posts: 1,766

    Mine are both at 70%. If I play Huntress or Deathslinger I turn it down to around 60 or so otherwise my shots will be a bit off.

    It's strange as I normally run max sensitivity in shooters but I just don't do well with it here.

    I've tried running both at max but as killer I end up whiffing because it spins so much and as survivor I end up turning too hard into loops. I could probably get used to it on max but eh, I like it where it's at now.

  • PigMainClaudette
    PigMainClaudette Member Posts: 3,842

    Xbox player, and unless I hate the sensitivity, I always just leave it on the default setting.

  • kate_best_girl
    kate_best_girl Member Posts: 2,184

    survivor 50-killer 82

  • tenoresax
    tenoresax Member Posts: 797

    100 for both, I used to play at around 60 and slowly pushed it up by 5 every few matches to ease myself up to 100 instead of just going all out and not being able to handle max sensitivity