Trapper Set In Place

shenanigans
shenanigans Member Posts: 15
in Feedback and Suggestions

Short and sweet: Let trapper hold M2 on an unset trap to set it where it lies.

This is currently a dumb interaction for him. At best he has to pick the trap up and put it back down. At worst he's at his carry limit and must place a trap in the wrong spot, pick up, place, and pick the first trap back up. He's probably the weakest killer in the game and the small buff and QoL improvement would be welcome.

Comments

  • yobuddd
    yobuddd Member Posts: 2,259

    98% agree! It’s an exceptionally irritating limitation.

    2% disagree: Weakest killer? I dunno..... I’ve seen very effective Trappers out there! 😎

  • KillermainBTWm8
    KillermainBTWm8 Member Posts: 4,212
    https://forum.deadbydaylight.com/en/discussion/comment/392383#Comment_392383

    He's a killer with no power at high ranks because of perks that can bypass traps and just bully the trapper *dead hard* and swf that follow him and disarm his traps and then if the survivors know what looking at the ground is they automatically ruin his power.

  • yobuddd
    yobuddd Member Posts: 2,259

    Fair enough. Admittedly I’ve seen some pretty bad trappers as well.

  • shenanigans
    shenanigans Member Posts: 15

    There are ways to work around his limitations and nail strong survivors with a bit of luck but the requirement for setup time makes him weak against gen rush. Run Ruin (and get a good totem spawn) or they'll have at least 2 gens up before you're even ready to go.

  • HazeHound
    HazeHound Member Posts: 814
    edited April 2019

    I think it would be a very deserved quality of life update!

    It would also be nice if traps that someone walked into stayed in the same place. Now they are moved to the side due to only 1 animation (there are 2 legs, but only one gets caught).

    Post edited by HazeHound on